Cisco Certified Network Associate (200-301 CCNA) – Question565


Refer to the exhibit. Which configuration must be applied to the router that configures PAT to translate all addresses in VLAN 200 while allowing devices on VLAN 100 to use their own IP addresses?

A. Router1(config)#access-list 99 permit 192.168.100.32 0.0.0.31
Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload
Router1(config)#interface gi2/0/1.200
Router1(config)#ip nat inside
Router1(config)#interface gi1/0/0
Router1(config)#ip nat outside
B. Router1(config)#access-list 99 permit 192.168.100.0 0.0.0.255
Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload
Router1(config)#interface gi2/0/1.200
Router1(config)#ip nat inside
Router1(config)#interface gi1/0/0
Router1(config)#ip nat outside
C. Router1(config)#access-list 99 permit 209.165.201.2 255.255.255.255
Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload
Router1(config)#interface gi2/0/1.200
Router1(config)#ip nat inside
Router1(config)#interface gi1/0/0
Router1(config)#ip nat outside
D. Router1(config)#access- list 99 permit 209.165.201.2 0.0.0.0
Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload
Router1(config)#interface gi2/0/1.200
Router1(config)#ip nat inside
Router1(config)#interface gi1/0/0
Router1(config)#ip nat outside

Correct Answer: A