Cisco Certified Network Associate (200-301 CCNA) – Question019

What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two.)

A. when Carrier Sense Multiple Access/Collision Detection is used
B. when one side of the connection is configured for half-duplex
C. when the sending device waits 15 seconds before sending the frame again
D. when a collision occurs after the 32nd byte of a frame has been transmitted
E. when the cable length limits are exceeded

Correct Answer: BE

Explanation:

Explanation:
A late collision is defined as any collision that occurs after the first 512 bits (or 64th byte) of the frame have been transmitted. The usual possible causes are full-duplex/half-duplex mismatch, exceeded Ethernet cable length limits, or defective hardware such as incorrect cabling, non-compliant number of hubs in the network, or a bad NIC.
Late collisions should never occur in a properly designed Ethernet network. They usually occur when Ethernet cables are too long or when there are too many repeaters in the network.
Reference:
https://www.cisco.com/en/US/docs/internetworking/troubleshooting/gu…