Which of the following is an environmental issue caused by electric storms or noisy electric equipment and may also cause computer system to hang or crash?
A. Sag
B. Blackout
C. Brownout
D. EMI
A. Sag
B. Blackout
C. Brownout
D. EMI
Correct Answer: D
Explanation:
Explanation:
The electromagnetic interference (EMI) caused by electrical storms or noisy electrical equipments. The interference may cause computer system to hang or crash as well as damages similar to those caused by sags, spike and surges.
Because Unshielded Twisted Pair cables does not have shielding like shielded twisted-pair cables, UTP is susceptible to interference from external electrical sources, which could reduce the integrity of the signal. Also, to intercept transmitted data, an intruder can install a tap on the cable or monitor the radiation from the wire. Thus, UTP may not be a good choice when transmitting very sensitive data or when installed in an environment with much electromagnetic interference (EMI) or radio frequency interference
(RFI). Despite its drawbacks, UTP is the most common cable type. UTP is inexpensive, can be easily bent during installation, and, in most cases, the risk from the above drawbacks is not enough to justify more expensive cables.
For your exam you should know below information about power failure
Total Failure (Blackout) – A complete loss of electric power, which may span from a single building to an entire geographical are and is often caused by weather conditions or inability of an electric utility company to meet user demands
Severely reduced voltage (brownout) – The failure of an electric utility company to supply power within acceptable range. Such a failure places a strain on electronic equipment and may limit their operational life or even cause permanent damage.
Sags, spike and surge – Temporary and rapid decreases (sag) or increases (spike and surges) in a voltage levels. These anomalies can cause loss of data, data corruption, network transmission errors or physical damage to hardware devices.
Electromagnetic interference (EMI) – The electromagnetic interference (EMI) caused by electrical storms or noisy electrical equipments. The interference may cause computer system to hang or crash as well as damages similar to those caused by sags, spike and surges.
The following were incorrect answers:
Sag – Temporarily rapid decrease in a voltage.
Total Failure (Blackout) – A complete loss of electric power, which may span from a single building to an entire geographical are and is often caused by weather conditions or inability of an electric utility company to meet user demands
Severely reduced voltage (brownout) – The failure of an electric utility company to supply power within acceptable range. Such a failure places a strain on electronic equipment and may limit their operational life or even cause permanent damage.
Reference:
CISA review manual 2014 Page number372 and
Hernandez CISSP, Steven (2012-12-21). Official (ISC)2 Guide to the CISSP CBK, Third Edition ((ISC)2 Press) (Kindle Locations 6507-6512). Acerbic Publications. Kindle Edition.
The electromagnetic interference (EMI) caused by electrical storms or noisy electrical equipments. The interference may cause computer system to hang or crash as well as damages similar to those caused by sags, spike and surges.
Because Unshielded Twisted Pair cables does not have shielding like shielded twisted-pair cables, UTP is susceptible to interference from external electrical sources, which could reduce the integrity of the signal. Also, to intercept transmitted data, an intruder can install a tap on the cable or monitor the radiation from the wire. Thus, UTP may not be a good choice when transmitting very sensitive data or when installed in an environment with much electromagnetic interference (EMI) or radio frequency interference
(RFI). Despite its drawbacks, UTP is the most common cable type. UTP is inexpensive, can be easily bent during installation, and, in most cases, the risk from the above drawbacks is not enough to justify more expensive cables.
For your exam you should know below information about power failure
Total Failure (Blackout) – A complete loss of electric power, which may span from a single building to an entire geographical are and is often caused by weather conditions or inability of an electric utility company to meet user demands
Severely reduced voltage (brownout) – The failure of an electric utility company to supply power within acceptable range. Such a failure places a strain on electronic equipment and may limit their operational life or even cause permanent damage.
Sags, spike and surge – Temporary and rapid decreases (sag) or increases (spike and surges) in a voltage levels. These anomalies can cause loss of data, data corruption, network transmission errors or physical damage to hardware devices.
Electromagnetic interference (EMI) – The electromagnetic interference (EMI) caused by electrical storms or noisy electrical equipments. The interference may cause computer system to hang or crash as well as damages similar to those caused by sags, spike and surges.
The following were incorrect answers:
Sag – Temporarily rapid decrease in a voltage.
Total Failure (Blackout) – A complete loss of electric power, which may span from a single building to an entire geographical are and is often caused by weather conditions or inability of an electric utility company to meet user demands
Severely reduced voltage (brownout) – The failure of an electric utility company to supply power within acceptable range. Such a failure places a strain on electronic equipment and may limit their operational life or even cause permanent damage.
Reference:
CISA review manual 2014 Page number372 and
Hernandez CISSP, Steven (2012-12-21). Official (ISC)2 Guide to the CISSP CBK, Third Edition ((ISC)2 Press) (Kindle Locations 6507-6512). Acerbic Publications. Kindle Edition.