CompTIA Server+ SK0-005 – Question110

An administrator is troubleshooting a failure in the datacenter in which a server shut down/powered off when utility power was lost. The server had redundant power supplies. Which of the following is the MOST likely cause of this failure?

A.
The UPS batteries were overcharged
B. Redundant power supplies require 220V power
C. Both power supplies were connected to the same power feed
D. The power supplies were not cross-connected

Correct Answer: C

CompTIA Server+ SK0-005 – Question108

An administrator is researching the upcoming licensing software requirements for an application that usually requires very little technical support. Which of the following licensing models would be the LOWEST cost solution?

A.
Open-source
B. Per CPU socket
C. Per CPU core
D. Enterprise agreement

Correct Answer: A

CompTIA Server+ SK0-005 – Question107

A server technician is installing a new server OS on legacy server hardware. Which of the following should the technician do FIRST to ensure the OS will work as intended?

A.
Consult the HCL to ensure everything is supported
B. Migrate the physical server to a virtual server
C. Low-level format the hard drives to ensure there is no old data remaining
D. Make sure the case and the fans are free from dust to ensure proper cooling

Correct Answer: A

CompTIA Server+ SK0-005 – Question106

A server administrator is deploying a UPS at a datacenter and notices the device is making an audible beep every few seconds. Which of the following is the MOST likely cause?

A.
The battery cable is disconnected
B. The device is plugged into the wrong outlet
C. The battery is faulty
D. The serial cable is not connected

Correct Answer: C

CompTIA Server+ SK0-005 – Question104

SIMULATION
A recent power outage caused email services to go down. A server administrator also received averts from the datacenter's UPS.
After some investigation, the server administrator learned that each PDU was rated at a maximum of 12A.
Instructions
Ensure power redundancy is implemented throughout each rack and UPS alarms are resolved. Ensure the maximum potential PDU consumption does not exceed 80% (or 9.6A).

a.
PDU selections must be changed using the penal icon
b. VM Hosts 1 and 2 and Mall Relay can be moved between racks
c. Certain devices contain additional details.












Correct Answer: See explanation below.

Explanation:

Explanation
1. Mailrelay – Keep the mail relay on the existing Rack1 and change the primary power supply to PDU-B and Failover powersupply as PDU B
2. Move the VM Host 1 and VM Host2 to Rack2.
Assign primary power supply PDU A to VM host1
Assign Failover power supply PDU B to VM host1
Assign primary power supply PDU B to VM host2
Assign Failover power supply PDU A to VM host2

CompTIA Server+ SK0-005 – Question103

A remote physical server is unable to communicate to the network through the available NICs, which were misconfigured. However, the server administrator is still able to configure the server remotely. Which of the following connection types is the server administrator using to access the server?

A.
Out-of-band management
B. Crash cart access
C. Virtual administrator console
D. Local KVM setup
E. RDP connection

Correct Answer: A

CompTIA Server+ SK0-005 – Question102

A server administrator needs to configure a server on a network that will have no more than 30 available IP addresses. Which of the following subnet addresses will be the MOST efficient for this network?

A.
255.255.255.0
B. 255.255.255.128
C. 255.255.255.224
D. 255.255.255.252

Correct Answer: C

CompTIA Server+ SK0-005 – Question101

A systems administrator has noticed performance degradation on a company file server, and one of the disks on it has a solid amber light. The administrator logs on to the disk utility and sees the array is rebuilding. Which of the following should the administrator do NEXT once the rebuild is finished?

A.
Restore the server from a snapshot.
B. Restore the server from backup.
C. Swap the drive and initialize the disk.
D. Swap the drive and initialize the array.

Correct Answer: C